Nissan Altima 2007-2012 Service Manual: Idle speed

Description

This describes how to check the idle speed. For the actual procedure, follow the instructions in “BASIC INSPECTION”.

Special Repair Requirement

1.CHECK IDLE SPEED

Check idle speed in “DATA MONITOR” mode with CONSULT-III.


Check idle speed in “DATA MONITOR” mode with CONSULT-III.

Check idle speed with Service $01 of GST.


Check idle speed with Service $01 of GST.

>> INSPECTION END

    Additional service when replacing control unit
     Description When replacing ECM, this procedure must be performed.  Special Repair Requirement 1.PERFORM INITIALIZATION OF NATS SYSTEM AND REGISTRATION OF ALL NATS IGNITION KEY IDS Ref ...

    Ignition timing
    Description This describes how to check the ignition timing. For the actual procedure, follow the instructions in “BASIC INSPECTION”. Special Repair Requirement 1.CHECK IGNITION TIMING ...

    Other materials:

    Hazard warning flasher switch
    Push the switch on to warn other drivers when you must stop or park under emergency conditions. All turn signal lights flash. WARNING ● If stopping for an emergency, be sure to move the vehicle well off the road. ● Do not use the hazard warning flashers while moving on the hig ...

    On-vehicle repair
    BATTERY Removal and Installation REMOVAL 1. Remove air duct (front). Refer to EM-25, "Removal and Installation" QR25DE models, EM-129, "Removal and Installation" VQ35DE models. 2. Loosen battery terminal nuts, and disconnect both battery terminals. CAUTION: When disc ...

    B2617 Starter relay circuit
    Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2617 is disp ...