Nissan Altima 2007-2012 Service Manual: Inspection and adjustment
- Basic inspection
- Additional service when replacing control unit
- Idle speed
- Ignition timing
- Vin registration
- Accelerator pedal released position learning
- Throttle valve closed position learning
- Idle air volume learning
- Mixture ratio self-learning value clear
Engine control system QR25DE except for california
Basic inspection
DIAGNOSIS AND REPAIR WORK FLOW
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1.GET INFORMATION FOR SYMPTOM
Get the detailed information from the customer about the symptom (the
c ...
Basic inspection
Special Repair Requirement
1.INSPECTION START
1. Check service records for any recent repairs that may indicate a related
malfunction, or a current need for
scheduled maintenance.
2. Open engi ...
Other materials:
Inside mirror
Exploded View
1. Inside mirror
2. Inside mirror finisher (if equipped)
3. Mirror base
Removal and Installation
1. Remove inside mirror finisher (if equipped).
2. Remove screw of mirror base.
3. Slide the mirror upward to remove.
4. Disconnect the connector (if equipped).
INSTALL ...
Secondary speed sensor
Exploded View
1. CVT assembly
2. Shims
3. O-ring
4. Secondary Speed Sensor
Removal and Installation
Refer to the figure for removal and installation.
CAUTION:
• Do not reuse O-ring.
• Apply CVT fluid to O-ring.
• Insert the shims.
• After installation is complete, check ...
Stall test
Inspection and Judgment
INSPECTION
1. Inspect the amount of engine oil. Replenish the engine oil if necessary.
2. Drive for about 10 minutes to warm up the vehicle so that the
CVT fluid temperature is 50 to 80°C (122 to 176°F). Inspect the
amount of CVT fluid. Replenish if necessary.
3. ...