Nissan Altima (L32) 2007-2012 Service Manual ≻ Lan system can system (type 9) ≻ M&A branch line circuit

Nissan Altima (L32) 2007-2012 Service Manual: M&A branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the terminals and connectors of the combination meter for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

1. Disconnect the connector of combination meter.

2. Check the resistance between the combination meter harness connector terminals.

Is the measurement value within the specification? YES >> GO TO 3.

NO >> Repair the combination meter branch line.

3.CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the combination meter. Refer to MWI-43, "COMBINATION METER : Diagnosis Procedure".

Is the inspection result normal? YES (Present error)>>Replace the combination meter. Refer to MWI-176, "Removal and Installation".

YES (Past error)>>Error was detected in the combination meter branch line.

NO >> Repair the power supply and the ground circuit.

DLC branch line circuit

Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors o ...

STRG branch line circuit

Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors o ...

Other materials:

Heater and air conditioner (automatic) (if so equipped)
AUTO (automatic) climate control button / temperature control dial (drivers side) Display screen Heated seat switches SYNC button / temperature control dial (passenger’s side) A/C (air conditioner) button Air recirculation button Air flow control button Fan speed control buttons Hea ...

Starting the vehicle
1. After starting the engine, fully depress the foot brake pedal before moving the shift lever out of the P (Park) position. The Continuously Variable Transmission is designed so the foot brake pedal MUST be depressed before shifting from P (Park) to any drive position while the ignition switch is i ...

USB/iPod charging ports (if so equipped)
Front (Type A) (if so equipped) Front (Type B) (if so equipped) Front (Type C) (if so equipped) Rear (if so equipped) Type-C USB Type-A USB There are USB charging ports located in the rear seat area on the back of the center console. These ports will charge compatible devices. NOTE: Not al ...