Nissan Altima 2007-2012 Service Manual: STRG branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the terminals and connectors of the steering angle sensor for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

1. Disconnect the connector of steering angle sensor.

2. Check the resistance between the steering angle sensor harness connector terminals.

Is the measurement value within the specification? YES >> GO TO 3.

NO >> Repair the steering angle sensor branch line.

3.CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the steering angle sensor. Refer to BRC-207, "Wiring Diagram - Coupe" or BRC-215, "Wiring Diagram - Sedan".

Is it normal? YES (Present error)>>Replace the steering angle sensor. Refer to BRC-242, "Removal and Installation" .

YES (Past error)>>Error was detected in the steering angle sensor branch line.

NO >> Repair the power supply and the ground circuit.

    M&A branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

    ABS branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

    Other materials:

    Thermostat and thermostat housing
    Removal and Installation 1. Gasket 2. Thermostat assembly WARNING: Never remove the radiator cap when the engine is hot. Serious burns could occur from high pressure coolant escaping from the radiator. REMOVAL CAUTION: Perform when engine is cool. 1. Drain engine coolant from the radiat ...

    Power steering solenoid valve
    Description • Power steering solenoid valve controls the power steering oil pressure in the gear housing assembly. Diagnosis Procedure 1.CHECK POWER STEERING SOLENOID VALVE SIGNAL 1. Start engine. 2. Check voltage between power steering control unit harness connector M59 terminal 1 and ...

    P0456 evap control system
    DTC Logic DTC DETECTION LOGIC This diagnosis detects very small leaks in the EVAP line between fuel tank and EVAP canister purge volume control solenoid valve, using the intake manifold vacuum in the same way as conventional EVAP small leak diagnosis. If ECM judges a leak which correspond ...