Nissan Altima 2007-2012 Service Manual: Mudguard
Removal and Installation
1. Center mudguard
A. C205 push pin
B. Splash guard screw
REMOVAL
1. Remove the C205 push-pins located on the under body.
2. Remove splash guard screws.
3. Remove the center mudguard screws and remove the center mudguard.
INSTALLATION
Installation is in the reverse order of removal.
Fender protector
Removal and Installation
1. Fender protector
2. Fender protector side cover
A. J-clips
B. Clips
C. Center mudguard screw
a. Sheet metal nut
REMOVAL
1. Remove the engine under cover. Refer ...
Door outside molding
Removal and Installation
1. Front door outside molding
2. Front door
Door Outside Molding
Removal
1. Open the front door window fully.
2. Remove the side view mirror. Refer to MIR-19, &quo ...
Other materials:
Service data and specifications
(SDS)
Standard and Limit
GENERAL SPECIFICATIONS
DRIVE BELTS
CYLINDER HEAD
* Approximately 80°C (176°F)
Available Valve Lifter
Valve Spring
CAMSHAFT AND CAMSHAFT BEARING
CYLINDER BLOCK
PISTON, PISTON RING, AND PISTON PIN
Available Piston
Piston Ring
CONNECT ...
Programming HomeLink® for Canadian customers and gate openers
Canadian radio-frequency laws require transmitter
signals to “time-out” (or quit) after several
seconds of transmission – which may not be long
enough for HomeLink® to pick up the signal
during training. Similar to this Canadian law,
some U.S. gate operators are designed to “timeout” ...
Power steering oil pump
QR25DE : Disassembly and Assembly
The power steering oil pump and pulley is not serviceable and should be
replaced as an assembly. For front
and rear bracket removal, refer to ST-19, "QR25DE : Removal and Installation".
VQ35DE : Disassembly and Assembly
The power steering oil pump an ...