Nissan Altima 2007-2012 Service Manual: On-vehicle repair
- Front bumper
- Rear bumper
- Front grille
- Cowl top
- Fender protector
- Mudguard
- Door outside molding
- Roof side molding
- License lamp finisher
On-vehicle maintenance
SQUEAK AND RATTLE TROUBLE DIAGNOSES
Work Flow
CUSTOMER INTERVIEW
Interview the customer, if possible, to determine the conditions that exist
when the noise occurs. Use the Diagnostic
Workshee ...
Front bumper
Removal and Installation
1. Front bumper supports
2. Front bumper side bracket
3. Reinforcement bracket
4. Front bumper reinforcement
5. Front energy absorbing foam
6. Front bumper fascia
7. ...
Other materials:
Normal operating condition
Description
FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED)
If the engine speed is above 1,800 rpm under no load (for example, the
selector lever position is neutral and
engine speed is over 1,800 rpm) fuel will be cut off after some time. The exact
time when the fuel is cut off varies
b ...
DLC branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the data link connector for damage,
bend and loose connection
(connector side and harness side) ...
Antenna AMP
Removal and Installation - Coupe
REMOVAL
1. Remove the rear pillar finisher RH. Refer to INT-15, "Removal and
Installation".
2. Detach the antenna amp harness clip (B), disconnect the
antenna amp connectors (A), remove the antenna amp screw
(C) and remove the antenna amp (1).
...