Nissan Altima 2007-2012 Service Manual: On-vehicle repair

On-vehicle maintenance
FRONT SUSPENSION ASSEMBLY Inspection and Adjustment INSPECTION Make sure the mounting conditions (looseness, back lash) of each component and component conditions (wear, damage) are normal. LOW ...

Front coil spring and strut
Removal and Installation REMOVAL 1. Remove wheel and tire. Refer to WT-66, "Adjustment". 2. Remove brake caliper and reposition aside using wire. Refer to BR-30, "BRAKE CALIPER A ...

Other materials:

P2014 tumble control valve position sensor
Description Tumble control valve position sensor is built into the tumble control valve actuator (2). 1 : Intake manifold adapter 3 : Tumble control valve The sensor consists of a permanent magnet and Hall IC. It senses the valve shaft movement and feeds the voltage signals to the ECM. DTC ...

Microphone
Removal and Installation REMOVAL 1. Remove the room/map lamp assembly. Refer to INL-121, "Removal and Installation". 2. Detach the microphone connector (A). 3. Remove the map lamp covers (1), then remove the map lamp assembly cover (2). 4. Release the microphone tabs (A), th ...

AMP On signal circuit
Description When the audio system is turned on, a voltage signal is supplied from the AV control unit to the BOSE speaker amp. When this signal is received, the BOSE speaker amp. will turn on. Diagnosis Procedure 1.CHECK AMP ON SIGNAL (BOSE SPEAKER AMP) 1. Turn audio system ON. 2. Check v ...