Nissan Altima 2007-2012 Service Manual: On-vehicle repair

Oil filter
Removal and Installation REMOVAL 1. Remove the engine undercover. 2. Remove the oil filter using Tool (A) as shown. Tool number : KV10115801 (J-38956) WARNING: • Be careful not to get burned ...

Oil pump
Removal and Installation REMOVAL 1. Remove the timing chain. Refer to EM-163, "Removal". 2. Remove oil pump assembly. INSTALLATION Installation is in the reverse order of removal. Di ...

Other materials:

Throttle valve closed position learning
 Description Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time harness connector of electric throttle control actuator or ECM is d ...

BSW system operation
The BSW system operates above approximately 20 MPH (32 km/h). When the camera unit detects vehicles in the detection zone, the Blind spot indicator light located inside the outside mirrors will illuminate. If the turn signal is then activated, the system chimes (twice) and the Blind spot i ...

Checking bulbs
With all doors closed, apply the parking brake and place the ignition switch to the ON position without starting the engine. The following lights will come on: The following lights (if equipped) come on briefly and then go off: If any light fails to come on, it may indicate a burned-out b ...