Nissan Altima 2007-2012 Service Manual: On-vehicle repair
STARTER MOTOR
Removal and Installation
M/T Models
REMOVAL
1. Disconnect the negative battery terminal.
2. Disconnect the starter motor harness connectors.
3. Remove the two starter motor bolts, using power tools.
4. Remove the starter motor.
INSTALLATION
1. Installation is in the reverse order of removal.
Removal and Installation
CVT Models
REMOVAL
1. Disconnect the negative and positive battery terminal.
2. Remove the air cleaner assembly and air ducts.
3. Disconnect the following: • ECM
• TCM
4. Remove the battery tray. For Sedan Refer PG-139, "Removal and Installation". For Coupe Refer to PG- 68, "Removal and Installation" 5. Disconnect the starter motor harness connectors.
6. Remove the two starter motor bolts, using power tools.
7. Remove the starter motor.
INSTALLATION
Installation is in the reverse order of removal.
Preparation
Special Service Tool
Commercial Service Tool
...
Service data and specifications
(SDS)
STARTER MOTOR
Starter
...
Other materials:
Door key cylinder switch
Description
Main power window and door lock/unlock switch detects condition of the door
key cylinder and transmits to
BCM as the LOCK or UNLOCK signals.
Component Function Check
1. CHECK DOOR KEY CYLINDER SWITCH INPUT SIGNAL
Check (“KEY CYL LK-SW”, “KEY CYL UN-SW”) in “DATA MONITOR ...
P0133 A/F sensor 1
Description
The air fuel ratio (A/F) sensor 1 is a planar one-cell limit current sensor.
The sensor element of the A/F sensor 1 is composed an electrode
layer, which transports ions. It has a heater in the element.
The sensor is capable of precise measurement = 1, but also in the
lean and r ...
Rear door glass
Exploded View
1. Rear door
2. Door glass run
3. Door glass
4. Inside seal
5. Partition sash
6. Rear window seal
7. Door rear, glass
8. Regulator assembly
9. Window motor
10. Water shield
Removal and Installation
REMOVAL
1. Remove the rear door finisher. Refer to INT-34, "Remova ...