Nissan Altima (L32) 2007-2012 Service Manual ≻ Power window control system lh only anti-pinch-coupe ≻ Component diagnosis ≻ Power window motor ≻ Passenger side

Nissan Altima (L32) 2007-2012 Service Manual: Passenger side

Description

Door glass moves UP/DOWN by receiving the signal from main power window and door lock/unlock switch or power window and door lock/unlock switch RH.

Component Function Check

1. CHECK FRONT POWER WINDOW MOTOR RH CIRCIUT

Does power window motor RH operate with main power window and door lock/unlock switch or power window and door lock/unlock switch? Is the inspection result normal? YES >> Power window motor RH is OK.

NO >> Refer to PWC-27, "PASSENGER SIDE : Diagnosis Procedure".

Diagnosis Procedure

Power Window Motor RH Circuit Check

1. CHECK POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH OUTPUT SIGNAL

1. Disconnect power window motor RH.

2. Turn ignition switch ON.

3. Check voltage between power window motor RH connector and ground.

Is the measurement value within the specification? YES >> GO TO 2

NO >> Replace power window and door lock/unlock switch RH. Refer to PWC-91, "Removal and Installation".

2. CHECK HARNESS CONTINUITY

1. Turn ignition switch OFF.

2. Disconnect power window and door lock/unlock switch RH.

3. Check continuity between power window and door lock/unlock switch RH connector (A) and power window motor RH connector (B).

4. Check continuity between power window and door lock/unlock switch connector (A) and ground.

Is the inspection result normal? YES >> GO TO 3

NO >> Repair or replace harness.

3. CHECK POWER WINDOW MOTOR RH

Check power window motor RH.

Refer to PWC-28, "PASSENGER SIDE : Component Inspection".

Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> Replace power window motor RH. Refer to GW-19, "Removal and Installation".

Component Inspection

COMPONENT INSPECTION

1. CHECK POWER WINDOW MOTOR RH

Does motor operate by connecting the battery voltage directly to power window motor RH?

Is the inspection result normal? YES >> Power window motor is OK.

NO >> Replace power window motor RH. Refer to GW-19, "Removal and Installation".

Driver side

Description Door glass moves UP/DOWN by receiving the signal from main power window and door lock/unlock switch. Component Function Check 1. CHECK POWER WINDOW MOTOR LH CIRCUIT Does power ...

Encoder

DRIVER SIDE Description Detects condition of the power window motor LH operation and transmits to main power window and door lock/unlock switch as pulse signal. Component Function Check 1. CH ...

Other materials:

Power supply and ground circuit
BCM Diagnosis Procedure 1. CHECK FUSE AND FUSIBLE LINK Check if the following BCM fuse or fusible link are blown. Is the fuse or fusible link blown? YES >> Replace the blown fuse or fusible link after repairing the affected circuit. NO >> GO TO 2 2. CHECK POWER SUPPLY CIRC ...

P2119 electric throttle control actuator
Description Electric throttle control actuator consists of throttle control motor, throttle position sensor, etc. The throttle control motor is operated by the ECM and it opens and closes the throttle valve. The throttle position sensor detects the throttle valve position, and the open ...

Power generation voltage variable control system operation inspection
Inspection Procedure CAUTION: When performing this inspection, always use a charged battery that has completed the battery inspection. (When the charging rate of the battery is low, the response speed of the voltage change will become slow. This can cause an incorrect inspection.) 1.CHECK ...