Nissan Altima 2007-2012 Service Manual: Power supply and ground circuit

Combination meter
Diagnosis Procedure 1.CHECK FUSES Check for blown combination meter fuses. Is the inspection result normal? YES >> GO TO 2 NO >> If fuse is blown, be sure to eliminate cause of malf ...

Other materials:

P2014 tumble control valve position sensor
Description Tumble control valve position sensor is built into the tumble control valve actuator (2). 1 : Intake manifold adapter 3 : Tumble control valve The sensor consists of a permanent magnet and Hall IC. It senses the valve shaft movement and feeds the voltage signals to the ECM. DTC ...

P0420 three way catalyst function
DTC Logic DTC DETECTION LOGIC The ECM monitors the switching frequency ratio of air fuel ratio (A/F) sensor 1 and heated oxygen sensor 2. A three way catalyst (manifold) with high oxygen storage capacity will indicate a low switching frequency of heated oxygen sensor 2. As oxygen storage c ...

Drip molding
Removal and Installation REMOVAL 1. Using a trim stick or equivalent, disconnect the drip mouldings starting at the front, working rearward. 2. Remove the drip moldings. INSTALLATION Installation is in the reverse order of removal. • Insert drip moldings onto vehicle starting at t ...