Nissan Altima 2007-2012 Service Manual: Power window retained power operation does not operate properly

Diagnosis Procedure

1. CHECK FRONT DOOR SWITCH

Check front door switch.

Refer to PWC-124, "Component Function Check".

Is the inspection result normal? YES >> Inspection end.

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Auto operation does not operate but manual operates normally (driver side)
    Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-108, "POWER WINDOW MAIN SWITCH : Special Repair Requirement". Is the inspectio ...

    Power window lock switch does not function
    Diagnosis Procedure 1.REPLACE MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH Replace main power window and door lock/unlock switch. Refer to PWC-186, "Removal and Installation". After th ...

    Other materials:

    On-vehicle repair
    COMBINATION METER Removal and Installation REMOVAL 1. Open the fuse block cover, remove the instrument lower cover screw (A), then remove the instrument lower cover (1). • Disconnect the harness connectors. • Disconnect the aspirator tube. 2. Remove the steering column screws (A), ...

    Additional service when removing battery negative terminal
    Description Initial setting is necessary when battery terminal is removed. CAUTION: The following specified operations are not performed under the non-initialized condition. • Auto-up operation • Anti-pinch function • Retained power operation Special Repair Requirement INITIALIZ ...

    Malfunction indicator lamp
    Description The Malfunction Indicator Lamp (MIL) is located on the combination meter. The MIL will light up when the ignition switch is turned ON without the engine running. This is a bulb check. When the engine is started, the MIL should go off. If the MIL remains on, the on board diagno ...