Nissan Altima 2007-2012 Service Manual: Rear seat
Exploded View
SPLIT REAR SEAT
1. Release strap
2. Rear seat lock assembly
3. Rear striker assembly
4. Rear seatback reinforcement
5. LH seatback frame
6. RH seatback frame
7. RH seatback pad
8. LH seatback pad
9. RH seatback trim
10. LH seatback trim
11. RH seatback hinge assembly
12. Seat cushion trim
13. Seat cushion pad
14. LH seatback hinge assembly
Removal and Installation
REMOVAL
1. Remove the rear seat cushion trim and pad.
• Pull the seat cushion upward to release the wire from the plastic hook, then pull the seat cushion forward to remove.
2. Remove the seat belt webbing from the guides.
3. Remove the seatback hinge anchor bolts and nut.
4. Remove the seatback assemblies.
INSTALLATION
Installation is in the reverse order of removal.
Front seat
Exploded View DRIVER'S SEAT 1. Headrest 2. Headrest holder (free) 3. Headrest holder (locked) 4. Seatback board 5. Seatback/frame assembly 6. Inner finisher 7. Seat belt buckle 8. Seat cus ...Disassembly and assembly
FRONT SEAT DRIVER SIDE Exploded View 1. Headrest 2. Headrest holder (locked) 3. Headrest holder (free) 4. Seatback board 5. Seatback/frame assembly 6. Inner finisher 7. Seat belt buc ...Other materials:
Malfunction indicator lamp
Description
The Malfunction Indicator Lamp (MIL) is located on the combination
meter.
The MIL will illuminate when the ignition switch is turned ON without
the engine running. This is a bulb check.
When the engine is started, the MIL should turn off. If the MIL
remains illuminated, the on ...
Cowl top
Removal and Installation
1. Cowl top seal
2. Cowl top side trim covers
3. Cowl top foam blocks
4. Cowl top
A Clips
REMOVAL
1. Remove both the RH and LH wiper arms. Refer to WW-116, "FRONT WIPER ARMS :
Removal and
Installation".
2. Remove the cowl top side trim covers.
3. ...
B260C steering lock unit
Description
The electronic steering column lock performs the check by itself according to
the steering status.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON.
2. Turn ignition switch OFF.
3. Press door switch ...