Nissan Altima 2007-2012 Service Manual: Rear view monitor system (sedan)

System Diagram

System Description

When the selector is in the R position, the display will show a view to the rear of the vehicle. Lines which indicate the vehicle clearance and distances are also displayed.

AV COMMUNICATION LINE

The rear view camera control unit is connected to the AV control unit using an AV communication line. This line is used to transmit and receive data.

Component Parts Location

1. Tweeter LH M51

2. Steering wheel audio control switches

3. CD changer M42

4. Tweeter RH M52

5. AV control unit M46, M47, M48, M81, M90, M91

6. Center speaker M151

7. Combination meter M24

8. Front door speaker

LH D3

RH D103

9. Rear subwoofer RH B124

10. Rear subwoofer LH B120

11. Rear door speaker

LH D202

RH D302

12. Antenna amp M502 (view with rear pillar finisher RH removed)

13. BOSE speaker amp. B121, B122

14. Microphone R7

15. Rear view camera control unit B31 (view with trunk side finisher LH removed)

16. Rear view camera B35

Component Description

    Rear view monitor system (coupe)
    System Diagram System Description When the selector is in the R position, the display shows a view to the rear of the vehicle. Lines which indicate the vehicle clearance and distances are also ...

    Audio system (coupe)
    System Diagram System Description AUDIO SYSTEM The audio system consists of the following components • AV control unit (audio unit) • BOSE speaker amp. • Window antenna • Steering w ...

    Other materials:

    Seat belt, buckles, retractors, anchors and adjusters
    Inspection CAUTION: • After any collision, inspect all seat belt assemblies, including retractors and other attached hardwares (I.e. anchor bolt, guide rail set). Nissan recommends to replace all seat belt assemblies in use during a collision, unless not damaged and properly operating afte ...

    How to switch the display
    A : Original screen before the RearView Monitor is operated B : Rear-wide view screen C : Rear view screen 1 : Shift lever is moved into the R (Reverse) position 2 : Shift lever is moved out of the R (Reverse) position 3 : Select the “View” key on the screen ● When the shift lev ...

    P0443 Evap canister purge volume control solenoid valve
    Description The EVAP canister purge volume control solenoid valve is used to control the flow rate of fuel vapor from the EVAP canister. The EVAP canister purge volume control solenoid valve is moved by ON/OFF pulses from the ECM. The longer the ON pulse, the greater the amount of fuel vapor th ...