Nissan Altima 2007-2012 Service Manual: Satellite radio tuner

Removal and Installation - Coupe

REMOVAL

1. Disconnect the battery negative terminal.

2. Remove the trunk floor carpet and spare tire cover. Refer to INT-23, "Removal and Installation".

3. Remove the LH trunk floor spacer.

4. Remove the Bluetooth control unit screws (A), then disconnect the Bluetooth control unit connectors and remove the Bluetooth control unit (1).

5. Remove the satellite radio tuner assembly nuts (C), and satellite radio tuner screw (D), disconnect the satellite radio tuner harness connectors and remove the satellite radio tuner and bracket assembly (2 and 3), then remove the satellite radio tuner screws (B) and remove satellite radio tuner (2) from the bracket (3).

NOTE: Bluetooth control unit (1) is removed with the satellite radio tuner (2) (if equipped).

INSTALLATION


INSTALLATION

Installation is in the reverse order of removal.

Removal and Installation - Sedan

REMOVAL

1. Disconnect the battery negative terminal.

2. Remove the rear parcel shelf finisher. Refer to INT-38, "Removal and Installation".

3. Remove the satellite radio tuner unit screws (A), disconnect the satellite tuner harness connectors and remove the satellite radio tuner (1).

NOTE: Bluetooth control unit (2) is removed with the satellite radio tuner unit (if equipped).

INSTALLATION


INSTALLATION

Installation is in the reverse order of removal.

    Subwoofer
    Components 1. Subwoofer speaker 2. Spacer A. Screws Removal and Installation REMOVAL 1. Remove the rear parcel shelf finisher. Refer to INT-17, "Removal and Installation" (coupe) ...

    Satellite radio antenna
    Removal and Installation REMOVAL 1. Lower the headliner at the rear. Refer to INT-20, "Removal and Installation" (coupe) and INT-42, "Removal and Installation" (sedan). 2. ...

    Other materials:

    Clutch master cylinder
    Removal and Installation REMOVAL 1. Remove the air cleaner and air duct. Refer to EM-19, "Removal and Installation" for QR25DE and EM- 123, "Removal and Installation" for VQ35DE. 2. Use one of the following methods to remove hose from master cylinder. • Drain clut ...

    Forward-facing child restraint installation using LATCH
    Refer to all Warnings and Cautions in the “Child Safety” and “Child Restraint” sections before installing a child restraint. Follow these steps to install a forward-facing child restraint using the LATCH system: 1. Position the child restraint on the seat. Always follow the child res ...

    Precaution
    Supplemental Restraint System (SRS) "AIR B AG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the dri ...