Nissan Altima 2007-2012 Service Manual: Service data and specifications (SDS)

Headlamp

*: Always check with the Parts Department for the latest parts information.

Exterior Lamp

*: Always check with the Parts Department for the latest parts information.

    Hazard switch
    Removal and Installation Removal 1. Remove the cluster lid C. Refer to IP-12, "Removal and Installation". 2. Remove CVT finisher or M/T finisher. Refer to TM-255, "Removal and In ...

    Other materials:

    How to follow trouble diagnoses
    Description NOTICE: Trouble diagnoses indicate work procedures required to diagnose problems effectively. Observe the following instructions before diagnosing. • Before performing trouble diagnoses, read the “Work Flow” in each section. • After repairs, re-check that the problem ...

    P0102, P0103 MAF sensor
    Description The mass air flow sensor (1) is placed in the stream of intake air. It measures the intake flow rate by measuring a part of the entire intake flow. The mass air flow sensor controls the temperature of the hot wire to a certain amount. The heat generated by the hot wire is reduced a ...

    Fuel pump
    Description *: ECM determines the start signal status by the signals of engine speed and battery voltage. The ECM activates the fuel pump for several seconds after the ignition switch is turned ON to improve engine start ability. If the ECM receives a engine speed signal from the camshaft ...