Nissan Altima Owners Manual: Servicing air conditioner

The air conditioner system in your NISSAN vehicle is charged with a refrigerant designed with the environment in mind.

This refrigerant does not harm the earths ozone layer.

Special charging equipment and lubricant is required when servicing your NISSAN air conditioner.

Using improper refrigerants or lubricants will cause severe damage to your air conditioner system. See Air conditioner system refrigerant and oil recommendations in the Technical and consumer information section of this manual.

A NISSAN dealer is able to service your environmentally friendly air conditioning system.

WARNING

The air conditioner system contains refrigerant under high pressure. To avoid personal injury, any air conditioner service should be done only by an experienced technician with proper equipment.

    Operating tips
    ● When the engine coolant temperature and outside air temperature are low, the air flow from the foot outlets may not operate for a maximum of 150 seconds. However, this is not a malfunction ...

    Other materials:

    P0011 IVT control
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0011 is displayed with DTC P0075, first perform the trouble diagnosis for EC-362, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF a ...

    B1xxx air bag diagnosis sensor unit
    Description DTC B1XXX AIR BAG DIAGNOSIS SENSOR UNIT The air bag diagnosis sensor unit will run self diagnostics when the ignition switch is turned ON. It has the potential to set many diagnostic trouble codes which will conform to the B1XXX format, but will not match any other SRS diagnosti ...

    Steering wheel switch for audio control
    1. Source select and power on switch 2. Menu control switch/ENTER button 3. (Back) switch 4. Volume control switch POWER on switch With the ignition switch in the ACC or ON position, push the SOURCE switch to turn the audio system on. SOURCE select switch Push the source select switch to ...