Nissan Altima Owners Manual: Monitor, climate, audio, phone and voice recognition systems

WARNING

● Positioning of the heating or air conditioning controls and display controls should not be done while driving in order that full attention may be given to the driving operation.

● Do not disassemble or modify this system.

If you do, it may result in accidents, fire, or electrical shock.

● Do not use this system if you notice any abnormality, such as a frozen screen or lack of sound. Continued use of the system may result in accident, fire or electric shock.

● In case you notice any foreign object in the system hardware, spill liquid on it, or notice smoke or smell coming from it, stop using the system immediately and contact your nearest NISSAN dealer. Ignoring such conditions may lead to accidents, fire or electrical shock.

Outside mirrors
WARNING ● Do not adjust the mirrors while driving. You could lose control of your vehicle and cause an accident. ● Objects viewed in the outside mirror on the passenger side are c ...

Control panel buttons — color screen with Navigation System (if so equipped)
1. PWR button/VOL (volume) control knob 2. Display screen 3. ENTER / AUDIO button / TUNE / SCROLL knob 4. BACK button 5. MAP button* 6. NAV button* 7. button 8. (brightness control) butto ...

Other materials:

P2423 HC adsorption catalyst function
DTC Logic DTC DETECTION LOGIC The ECM monitors the phase gap between heated oxygen sensor 2 signal and heated oxygen sensor 3 signal. The phase gap between heated oxygen sensor 2 signal and heated oxygen sensor 3 signal becomes small as the HC adsorption catalyst (under floor) is deteriorate ...

P0122, P0123 TP sensor
Description Electric throttle control actuator consists of throttle control motor, throttle position sensor, etc. The throttle position sensor responds to the throttle valve movement. The throttle position sensor has two sensors. These sensors are a kind of potentiometer which transform the ...

Main line between dlc and abs circuit
Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side). - Harness co ...