Nissan Altima 2007-2012 Service Manual: Sound signal circuit (sedan)

SATELLITE RADIO TUNER

Description

Left and right channel audio signals are supplied from the satellite radio tuner to the audio unit through the sound signal circuits.

Diagnosis Procedure

LEFT CHANNEL

1.CHECK HARNESS

1. Turn ignition switch OFF.

2. Disconnect satellite radio tuner (factory installed) connector B123 and audio unit connector M45.

3. Check continuity between satellite radio tuner (factory installed) connector B123 (A) and audio unit connector M45 (B).

4. Check continuity between satellite radio tuner (factory installed) connector B123 (A) and ground.

Are continuity results as specified? YES >> GO TO 2

NO >> Repair harness or connector.

2.CHECK LEFT CHANNEL AUDIO SIGNAL

1. Connect satellite radio tuner (factory installed) and audio unit.

2. Turn ignition switch ON.

3. Check signal between satellite radio tuner (factory installed) connector B123 terminals 21 and 22 with CONSULT-III or oscilloscope.

Are voltage readings as specified? YES >> Replace audio unit. Refer to AV-72, "Removal and Installation".

NO >> Replace satellite radio tuner. Refer to AV-223, "Removal and Installation - Sedan".

RIGHT CHANNEL

1.CHECK HARNESS

1. Turn ignition switch OFF.

2. Disconnect satellite radio tuner (factory installed) connector B123 and audio unit connector M45.

3. Check continuity between satellite radio tuner (factory installed) connector B123 (A) and audio unit connector M45 (B).

4. Check continuity between satellite radio tuner (factory installed) connector B123 (A) and ground.

4. Check continuity between satellite radio tuner (factory installed) connector B123 (A) and ground.

NO >> Repair harness or connector.

2.CHECK RIGHT CHANNEL AUDIO SIGNAL

1. Connect satellite radio tuner (factory installed) and audio unit.

2. Turn ignition switch ON.

3. Check signal between satellite radio tuner (factory installed) connector B123 terminals 23 and 24 with CONSULT-III or oscilloscope.

Are voltage readings as specified? YES >> Replace audio unit. Refer to AV-72, "Removal and Installation".

NO >> Replace satellite radio tuner. Refer to AV-223, "Removal and Installation - Sedan".

    Sound signal circuit (coupe)
    SATELLITE RADIO TUNER Description Left and right channel audio signals are supplied from the satellite radio tuner to the audio unit through the sound signal circuits. Diagnosis Procedure LEFT ...

    Other materials:

    P1574 ASCD Vehicle speed sensor
    Description The ECM receives two vehicle speed signals via the CAN communication line. One is sent from combination meter, and the other is from TCM (Transmission control module). The ECM uses these signals for ASCD control. Refer to EC-1090, "System Diagram" for ASCD functions. ...

    U1000 Can comm circuit
    Description Refer to AV-240, "System Description". DTC Logic DTC DETECTION LOGIC Diagnosis Procedure Symptom: Displays “CAN COMM CIRCUIT [U1000]” as a self-diagnosis result of AV control unit. 1.CHECK CAN COMMUNICATION Select “SELF-DIAG RESULTS” mode for “MULTI AV” w ...

    Service data and specifications (SDS)
    Standard and Limit GENERAL SPECIFICATIONS DRIVE BELTS CYLINDER HEAD * Approximately 80°C (176°F) Available Valve Lifter Valve Spring CAMSHAFT AND CAMSHAFT BEARING CYLINDER BLOCK PISTON, PISTON RING, AND PISTON PIN Available Piston Piston Ring CONNECT ...