Nissan Altima 2007-2012 Service Manual: Sound signal circuit (coupe)

SATELLITE RADIO TUNER

Description

Left and right channel audio signals are supplied from the satellite radio tuner to the audio unit through the sound signal circuits.

Diagnosis Procedure

LEFT CHANNEL

1.CHECK HARNESS

1. Turn ignition switch OFF.

2. Disconnect satellite radio tuner (factory installed) connector B57 and audio unit connector M45.

3. Check continuity between satellite radio tuner (factory installed) connector B57 (A) and audio unit connector M45 (B).

4. Check continuity between satellite radio tuner (factory installed) connector B57 (A) and ground.

Are continuity results as specified? YES >> GO TO 2

NO >> Repair harness or connector.

2.CHECK LEFT CHANNEL AUDIO SIGNAL

1. Connect satellite radio tuner (factory installed) and audio unit.

2. Turn ignition switch ON.

3. Check signal between satellite radio tuner (factory installed) connector B57 terminals 21 and 22 with CONSULT-III or oscilloscope.

Are voltage readings as specified? YES >> Replace audio unit. Refer to AV-72, "Removal and Installation".

NO >> Replace satellite radio tuner. Refer to AV-223, "Removal and Installation - Coupe".

RIGHT CHANNEL

1.CHECK HARNESS

1. Turn ignition switch OFF.

2. Disconnect satellite radio tuner (factory installed) connector B57 and audio unit connector M45.

3. Check continuity between satellite radio tuner (factory installed) connector B57 (A) and audio unit connector M45 (B).

4. Check continuity between satellite radio tuner (factory installed) connector B57 (A) and ground.

Are continuity results as specified? YES >> GO TO 2

NO >> Repair harness or connector.

2.CHECK RIGHT CHANNEL AUDIO SIGNAL

1. Connect satellite radio tuner (factory installed) and audio unit.

2. Turn ignition switch ON.

3. Check signal between satellite radio tuner (factory installed) connector B57 terminals 23 and 24 with CONSULT-III or oscilloscope.

Are voltage readings as specified? YES >> Replace audio unit. Refer to AV-72, "Removal and Installation".

NO >> Replace satellite radio tuner. Refer to AV-223, "Removal and Installation - Coupe".

    Communication signal circuit (sedan)
    SATELLITE RADIO TUNER Description Communication signals are exchanged between the audio unit and satellite radio tuner using the communication circuits.  Diagnosis Procedure 1.CHECK HARNE ...

    Sound signal circuit (sedan)
    SATELLITE RADIO TUNER Description Left and right channel audio signals are supplied from the satellite radio tuner to the audio unit through the sound signal circuits. Diagnosis Procedure LEF ...

    Other materials:

    U1000 can comm circuit
    Description Refer to LAN-7, "System Description". DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE Diagnosis Procedure 1. PERFORM SELF DIAGNOSTIC 1. Turn ignition switch ON and wait for 2 second or more. 2. Check “Self Diagnostic Result” of IPDM E/R. Is “CAN C ...

    Additional service when removing battery negative terminal
    Description Initial setting is necessary when battery terminal is removed. CAUTION: The following specified operations are not performed under the non-initialized condition. • Auto-up operation • Anti-pinch function • Retained power operation Special Repair Requirement INITIALIZAT ...

    P0776 pressure control solenoid B performance (sec pressure solenoid valve)
    Description The pressure control solenoid valve B (secondary pressure solenoid valve) regulates the secondary pressure to suit the driving condition in response to a signal sent from the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe ...