Nissan Altima Owners Manual: Startup display

When the vehicle in placed in the ON or ACC position the screens that display in the vehicle information include:
● Active system status (if so equipped) ● Trip computer
● Tire pressure information (if so equipped) ● Fuel economy
● Warnings

Warnings will only display if there are any present, for more information on warnings and indicators see, “Vehicle information display warnings and indicators” in this section.

To control what items display in the vehicle information display, see “Main menu selection” in this section.

    How to use the vehicle information display
    The vehicle information display can be changed using the buttons and ENTER located on the steering wheel. 1. — navigate through the items in vehicle information ENTER — change or se ...

    Settings
    The setting mode allows you to change the information displayed in the vehicle information display: ● Driver Assistance (if so equipped) ● Main Menu Selection ● Body Color χ ...

    Other materials:

    B26e1 no reception of engine status signal
    Description BCM receives the engine status signal from ECM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B26E1 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-433, "DTC Logic". • If DTC B26E1 is displayed w ...

    Roof side molding
    Removal and Installation 1. Body side outer panel 2. Windshield 3. Roof REMOVAL 1. Lift and twist the roof side molding up from the rear edge. 2. Disconnect the roof side molding from the clips, and remove the roof side molding. INSTALLATION Installation is in the reverse order of ...

    P0300, P0301, P0302, P0303, P0304 Misfire
    DTC Logic DTC DETECTION LOGIC When a misfire occurs, engine speed will fluctuate. If the engine speed fluctuates enough to cause the crankshaft position (CKP) sensor (POS) signal to vary, ECM can determine that a misfire is occurring. The misfire detection logic consists of the following ...