Nissan Altima 2007-2012 Service Manual: Subwoofer

Components

1. Subwoofer speaker

2. Spacer

A. Screws

Removal and Installation

REMOVAL

1. Remove the rear parcel shelf finisher. Refer to INT-17, "Removal and Installation" (coupe) and INT-38, "Removal and Installation" (sedan).

2. Remove the trunk front finisher. Refer to INT-23, "Removal and Installation" (coupe) and INT-46, "Removal and Installation" (sedan).

3. Remove the subwoofer speaker screws from the top, disconnect the subwoofer speaker harness connector and remove the subwoofer speaker and spacer assembly.

4. Remove the spacer screws and remove the subwoofer speaker from the spacer.

INSTALLATION

Installation is in the reverse order of removal.

    Rear tweeter
    Removal and Installation - Coupe REMOVAL 1. Remove the rear parcel shelf finisher. Refer to INT-17, "Removal and Installation". 2. Remove the rear tweeter speaker screws (A) and remov ...

    Satellite radio tuner
    Removal and Installation - Coupe REMOVAL 1. Disconnect the battery negative terminal. 2. Remove the trunk floor carpet and spare tire cover. Refer to INT-23, "Removal and Installation" ...

    Other materials:

    P0452 evap control system pressure sensor
    Description The EVAP control system pressure sensor detects pressure in the purge line. The sensor output voltage to the ECM increases as pressure increases. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously cond ...

    Power window main switch
    Description Main power window and door lock/unlock switch, power window and door lock/unlock switch RH and BCM transmit and receive the signal by power window serial link. The signal mentioned below is transmitted from BCM to main power window and door lock/unlock switch and power window ...

    Low tire pressure warning lamp stays on
    Low Tire Pressure Warning Lamp Stays On When Ignition Switch Is Turned On DIAGNOSTIC PROCEDURE 1.CHECK BCM CONNECTORS 1. Turn ignition switch OFF. 2. Disconnect BCM harness connectors. 3. Check terminals for damage or loose connections. Is the inspection result normal? YES >> GO ...