Nissan Altima 2007-2012 Service Manual: Satellite radio tuner

Removal and Installation - Coupe

REMOVAL

1. Disconnect the battery negative terminal.

2. Remove the trunk floor carpet and spare tire cover. Refer to INT-23, "Removal and Installation".

3. Remove the LH trunk floor spacer.

4. Remove the Bluetooth control unit screws (A), then disconnect the Bluetooth control unit connectors and remove the Bluetooth control unit (1).

5. Remove the satellite radio tuner assembly nuts (C), and satellite radio tuner screw (D), disconnect the satellite radio tuner harness connectors and remove the satellite radio tuner and bracket assembly (2 and 3), then remove the satellite radio tuner screws (B) and remove satellite radio tuner (2) from the bracket (3).

NOTE: Bluetooth control unit (1) is removed with the satellite radio tuner (2) (if equipped).

INSTALLATION

Installation is in the reverse order of removal.

Removal and Installation - Sedan

REMOVAL

1. Disconnect the battery negative terminal.

2. Remove the rear parcel shelf finisher. Refer to INT-38, "Removal and Installation".

3. Remove the satellite radio tuner unit screws (A), disconnect the satellite tuner harness connectors and remove the satellite radio tuner (1).

NOTE: Bluetooth control unit (2) is removed with the satellite radio tuner unit (if equipped).

INSTALLATION

Installation is in the reverse order of removal.

    Subwoofer
    Components 1. Subwoofer speaker 2. Spacer A. Screws Removal and Installation REMOVAL 1. Remove the rear parcel shelf finisher. Refer to INT-17, "Removal and Installation" (coupe) ...

    Satellite radio antenna
    Removal and Installation REMOVAL 1. Lower the headliner at the rear. Refer to INT-20, "Removal and Installation" (coupe) and INT-42, "Removal and Installation" (sedan). 2. ...

    Other materials:

    AV Branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the AV control unit for damage, bend and loose connection (unit side and connector side). I ...

    P0139 HO2S2
    Description The heated oxygen sensor 2, after three way catalyst (manifold), monitors the oxygen level in the exhaust gas on each bank. Even if switching characteristics of the air fuel ratio (A/F) sensor 1 are shifted, the air-fuel ratio is controlled to stoichiometric, by the signal from th ...

    P2118 Throttle control motor
    Description The throttle control motor is operated by the ECM and it opens and closes the throttle valve. The current opening angle of the throttle valve is detected by the throttle position sensor. The throttle position sensor it provides feedback to the ECM, when opens/closes the throttle ...