Nissan Altima 2007-2012 Service Manual: TCM branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).

- TCM

- Harness connector F1

- Harness connector E3

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

1. Disconnect the connector of TCM.

2. Check the resistance between the TCM harness connector terminals.

Is the measurement value within the specification? YES >> GO TO 3.

NO >> Repair the TCM branch line.

3.CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the TCM. Refer to the following.

• QR25DE models: TM-380, "Wiring Diagram - CVT CONTROL SYSTEM - Coupe" or TM-389, "Wiring Diagram - CVT CONTROL SYSTEM - Sedan" • VQ35DE models: TM-202, "Wiring Diagram—CVT CONTROL SYSTEM—Coupe" or TM-211, "Wiring Diagram— CVT CONTROL SYSTEM—Sedan" Is the inspection result normal? YES (Present error)>>Replace the TCM. Refer to the following.

• QR25DE models: TM-430, "Exploded View" • VQ35DE models: TM-254, "Exploded View" YES (Past error)>>Error was detected in the TCM branch line.

NO >> Repair the power supply and the ground circuit.

    ABS branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

    IPDM-E branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors o ...

    Other materials:

    Front power window switch
    Description Main power window and door lock/unlock switch, power window and door lock/unlock switch RH and BCM transmit and receive the signal by power window serial link. The signal mentioned below is transmitted from BCM to main power window and door lock/unlock switch and power window a ...

    Rear view camera control unit
    Diagnosis Procedure 1.CHECK FUSE Check that the following fuses of the rear view camera control unit are not blown. Are the fuses OK? YES >> GO TO 2 NO >> Be sure to eliminate cause of malfunction before installing new fuse. 2.CHECK POWER SUPPLY CIRCUIT Check voltage between r ...

    Power steering fluid
    Check the fluid level in the reservoir. The fluid level should be checked when the fluid is cold at fluid temperatures of 0 to 30ºC (32 to 86ºF). The fluid level can be checked with the level gauge which is attached to the cap. To check the fluid level, remove the cap. The fluid ...