Nissan Altima 2007-2012 Service Manual: Trunk room trim & trunk lid finisher
Exploded View
TRUNK ROOM TRIM
1. Trunk lid finisher
2. Trunk lid rubber bumper
3. Trunk net rear
4. Trunk rear finisher
5. Trunk side finisher (RH)
6. Trunk floor carpet
7. Spare tire cover
8. Trunk floor board (LH)
9. Trunk side finisher (LH)
10. Trunk net side
A. Clip C205
B. Clip - hook type
Removal and Installation
REMOVAL
TRUNK ROOM TRIM
1. Release the latch, then position rear seatback (RH/LH) to the folded down position.
2. Release the clips, then remove trunk floor carpet.
3. Remove trunk net rear and trunk net side (if installed).
4. Release the clips, then remove trunk rear finisher.
5. Release the clips, then remove trunk side finisher (RH/LH).
6. Remove spare tire cover and trunk floor board (LH).
7. Remove the trunk lid rubber bumper (RH/LH), then release the clips and remove trunk lid finisher.
INSTALLATION
Installation is in the reverse order of removal.
Headlining
Exploded View
1. Room/Map lamp assembly
2. Mirror harness cover
3. Sunvisor holder
4. Sunvisor
5. Sunvisor cover
6. Headlining assembly (without sunroof)
7. Headlining assembly (with
sunroo ...
Instrument panel
...
Other materials:
Air cleaner filter
Removal and Installation
1. Air duct hose
2. Air cleaner filter
3. Air cleaner case (front)
4. Front air duct
5. Air cleaner mounting bracket
6. Air cleaner case (rear)
7. Mass air flow sensor
A. To electric throttle control actuator
B. Air cleaner case side clips
CHANGING THE AIR CLEANE ...
P0720 vehicle speed sensor cvt (secondary
speed sensor)
Description
The vehicle speed sensor CVT [output speed sensor (secondary speed sensor)]
detects the revolution of the
CVT output shaft and emits a pulse signal. The pulse signal is transmitted to
the TCM, which converts it into
vehicle speed.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMAT ...
Engine oil
Changing Engine Oil
WARNING:
• Be careful not to burn yourself, as the engine oil may be hot.
• Prolonged and repeated contact with used engine oil may cause skin cancer; try
to avoid direct skin
contact with used oil. If skin contact is made, wash thoroughly with soap or
hand cleaner ...