Nissan Altima (L32) 2007-2012 Service Manual: ASCD indicator
Description
The ASCD operation status is indicated by two indicators, (CRUISE and SET on
the information display) on
the combination meter.
CRUISE indicator is displayed to indicate that ASCD system is ready for
operation when MAIN switch on
ASCD steering switch is turned ON.
SET indicator is displayed when the following conditions are met.
• CRUISE indicator is displayed.
• SET/COAST switch on ASCD steering switch is turned ON while vehicle speed is
within the range of ASCD
setting.
SET indicator is displayed during ASCD control.
Refer to EC-67, "System Description" for the ASCD function.
Component Function Check
1.ASCD INDICATOR FUNCTION
Is the inspection result normal?
YES >> INSPECTION END
NO >> Go to EC-455, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK DTC
Check that DTC UXXXX is not displayed.
Is the inspection result normal?
YES >> GO TO 2.
NO >> Perform trouble diagnosis for DTC UXXXX.
2.CHECK COMBINATION METER OPERATION
Refer to MWI-38, "CONSULT-III Function (METER/M&A)".
Is the inspection result normal?
YES >> GO TO 3.
NO >> Check combination meter circuit. Refer to MWI-5, "METER SYSTEM : System
Diagram".
3.CHECK INTERMITTENT INCIDENT
Refer to GI-42, "Intermittent Incident".
>> INSPECTION END
Description
When the brake pedal is depressed, ASCD brake switch is turned OFF and stop
lamp switch is turned ON.
ECM detects the state of the brake pedal by this input of two kinds (ON/OFF
si ...
Description
The ECM controls the cooling fan corresponding to the vehicle speed, engine
colant temperature, refrigerant
pressure, and air conditioner ON signal. The control system has 4-step cont ...
Other materials: Cleaning exterior
In order to maintain the appearance of
your vehicle, it is important to take proper
care of it.
To protect the paint surfaces, wash your
vehicle as soon as you can:
After a rainfall to prevent possible damage
from acid rain.
After driving on coastal roads.
When contaminants such as soot, bird
...
Turning the I-FCW system on/off
For vehicles with the 7 inch (18 cm) display
Perform the following steps to turn the
I-FCW system ON or OFF.
For vehicles with the 7 inch (18 cm) display.
1. Press thebutton until
"Settings" displays
in the vehicle information display.
Use the button to select "Driver
Assistance."
Then press the ...
Brakes
If the brakes do not operate properly, have
the brakes checked. It is recommended
that you visit a NISSAN dealer for this
service.
Self-adjusting brakes
Your vehicle is equipped with self-adjusting
brakes.
The front and rear disc-type brakes self-adjust
every time the brake pedal is
applied.
WARNIN ...