Nissan Altima Owners Manual: Automatic anti-glare rearview mirror (if so equipped)
The inside mirror is designed so that it automatically dims during night time conditions and according to the intensity of the headlights of the vehicle following you. The automatic anti-glare feature is activated when the ignition switch is in the ON position.
The indicator light will illuminate when the automatic anti-glare feature is operating.
NOTE:
Do not hang any objects over the sensors 1 or apply glass cleaner to the sensors.
Doing so will reduce the sensitivity of the sensors, resulting in improper operation.
Type A - Without compass
Type A and Type B
The indicator light 2 will illuminate when the automatic anti-glare feature is operating.
To turn off the automatic anti-glare feature, press:
● the button for inside mirrors
without
compass.
● the button for inside mirrors
with
compass.
The indicator light will turn off.
Type B - With compass
To turn on the automatic anti-glare feature again,
press:
● the | button for inside mirrors without
compass.
● the button for inside mirrors
with
compass.
The indicator light will turn on.
For information on HomeLink® Universal Transceiver operation, see the “HomeLink® Universal Transceiver” in the “Instruments and controls” section of this manual.
For information on the compass display (if so equipped), see “Compass display” in the “Instruments and controls” section of this manual.
Rearview mirror (if so equipped)
The night position 1 reduces glare from the
headlights of vehicles behind you at night.
Use the day position 2 when driving in daylight
hours.
WARNING
Use the night position only when necessa ...
Outside mirrors
WARNING
● Do not adjust the mirrors while driving.
You could lose control of your vehicle
and cause an accident.
● Objects viewed in the outside mirror on
the passenger side are c ...
Other materials:
Low-pressure flexible hose
Removal and Installation for Low-Pressure Flexible
Hose
QR25DE
Removal
1. Discharge the refrigerant. Refer to HA-32, "HFC-134a (R-134a) Service
Procedure".
2. Remove the low-pressure flexible hose. Refer to HA-31, "Component".
CAUTION:
Cap or wrap the joint of the h ...
Front coil spring and strut
Removal and Installation
REMOVAL
1. Remove wheel and tire. Refer to WT-66, "Adjustment".
2. Remove brake caliper and reposition aside using wire. Refer to BR-30, "BRAKE
CALIPER ASSEMBLY :
Exploded View".
CAUTION:
Avoid depressing brake pedal with brake caliper removed ...
P1726 electric throttle control
system
Description
Electric throttle control actuator consists of throttle control motor,
accelerator pedal position sensor, throttle
position sensor etc. The actuator sends a signal to the ECM, and ECM sends the
signal to TCM with CAN
communication.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMAT ...