Nissan Altima Owners Manual: Pre-driving checks and adjustments

If your vehicle is stolen
If your vehicle is stolen, you should change the codes of any non-rolling code device that has been programmed into HomeLink®. Consult the Owner’s Manual of each device or call the manufacturer ...

Keys
Type A 1. Intelligent Key (2 sets) 2. Mechanical key 3. Key number plate (1 plate) ...

Other materials:

Steering wheel
Inspection INSTALLATION CONDITION • Check installation conditions of steering gear assembly, front suspension assembly, axle and steering column assembly. • Check if movement exists when steering wheel is moved up and down, to the left and right and to the axial direction. Steering w ...

B210D starter relay
Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B210D is display ...

Anti-pinch system does not operate normally (driver side)
Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-190, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement". Is the inspection result normal? YES >> GO TO 2 NO >> Repair or replace the ma ...