Nissan Altima Owners Manual: Outside mirrors
WARNING
● Do not adjust the mirrors while driving.
You could lose control of your vehicle and cause an accident.
● Objects viewed in the outside mirror on the passenger side are closer than they appear. Be careful when moving to the right. Using only this mirror could cause an accident. Use the inside mirror or glance over your shoulder to properly judge distances to other objects.
The outside mirror remote control only operates when the ignition switch is placed in the ACC or ON position.
Move the small switch 1 to select the right or left mirror. Adjust each mirror to the desired position using the large switch 2 .
Heated mirrors (if so equipped)
Some outside mirrors can be heated to defrost, defog, or de-ice for improved visibility. For additional information, see “Rear window and outside mirror defroster switch” in the “Instruments and controls” section of this manual.
Manual folding outside mirrors (if so equipped)
Pull the outside mirror toward the door to fold it.
Automatic anti-glare rearview mirror (if so equipped)
The inside mirror is designed so that it automatically
dims during night time conditions and according
to the intensity of the headlights of the
vehicle following you. The automatic anti-glare
fea ...
Monitor, climate, audio, phone and voice
recognition systems
WARNING
● Positioning of the heating or air conditioning
controls and display controls
should not be done while driving in order
that full attention may be given to
the driving operation.
...
Other materials:
Bluetooth® Hands-Free Phone System without Navigation System (Type B) (if so
equipped
WARNING
● Use a phone after stopping your vehicle
in a safe location. If you have to use a
phone while driving, exercise extreme
caution at all times so full attention may
be given to vehicle operation.
● If you are unable to devote full attention
to vehicle operation while talkin ...
Door switch
Description
Detects door open/close condition and transmits the signal to BCM.
Component Function Check
1. CHECK DOOR SWITCH INPUT SIGNAL
Check (“DOOR SW-DR” and “DOOR SW-AS”) in “DATA MONITOR” mode with
CONSULT-III. Refer to BCS-
34, "RETAINED PWR : CONSULT-III Function (BC ...
P0143 HO2S3
Description
The heated oxygen sensor 3, after HC adsorption catalyst (Under
floor), monitors the oxygen level in the exhaust gas on each bank.
This sensor is made of ceramic zirconia. The zirconia generates voltage
from approximately 1V in richer conditions to 0V in leaner conditions.
Unde ...