Nissan Altima 2007-2012 Service Manual: Back-up lamp
Bulb Replacement
Removal
1. Remove the rear combination lamp. Refer to EXL-260, "Removal and Installation".
2. Turn back-up lamp bulb socket counterclockwise to unlock and remove.
3. Pull back-up lamp bulb from socket to remove.
Installation
Installation is in the reverse order of removal.
Stop lamp
Bulb Replacement
Removal
1. Remove rear combination lamp. Refer to EXL-257, "Removal and
Installation".
2. Turn bulb socket counterclockwise to unlock and remove from combination lam ...
License plate lamp
Bulb Replacement
REMOVAL
1. Position trunk lid finisher aside.
2. Turn license plate lamp bulb socket counterclockwise to unlock
and remove.
3. Pull license plate lamp bulb to remove from so ...
Other materials:
On-vehicle repair
STARTER MOTOR
Removal and Installation
M/T MODELS
Removal
1. Disconnect the negative battery terminal.
2. Disconnect the starter motor harness connectors.
3. Remove the two starter motor bolts, using power tools.
4. Remove the starter motor.
Installation
Installation is in the reverse ...
B1209 – b1210 collision detection
Description
DTC B1209 - B1210 COLLISION DETECTION
The air bag diagnosis sensor unit will set this DTC if it has detected a
collision which has resulted in a frontal
or side deployment of one or more air bags or pre-tensioners. If this DTC is
detected after a SRS repair, the
air bag diagnosis ...
Steering switch (sedan)
Description
When one of the steering wheel audio control switches is pushed, the
resistance in steering switch circuit
changes depending on which button is pushed.
Diagnosis Procedure
WITH BLUETOOTH
1.CHECK HARNESS
1. Turn ignition switch OFF.
2. Disconnect Bluetooth control unit connect ...