Nissan Altima 2007-2012 Service Manual: Back-up lamp switch
Removal and Installation
For removal and installation of back-up lamp switch, refer to TM-28, "Exploded View".
Inspection
• Check continuity.
Side oil seal
Removal and Installation
REMOVAL
1. Remove the drive shaft. Refer to FAX-11, "Removal and Installation (Left
Side)", FAX-12, "Removal and
Installation (Right Side)".
2. Rem ...
Park/neutral position switch
Removal and Installation
For removal and installation of park/neutral position switch, refer to TM-28,
"Exploded View".
Inspection
• Check continuity.
...
Other materials:
Accelerator pedal released position
learning
Description
Accelerator Pedal Released Position Learning is a function of ECM to learn
the fully released position of the
accelerator pedal by monitoring the accelerator pedal position sensor output
signal. It must be performed each
time the harness connector of the accelerator pedal p ...
P0101 maf sensor
Description
The mass air flow sensor (1) is placed in the stream of intake air. It
measures the intake flow rate by measuring a part of the entire
intake flow. The mass air flow sensor controls the temperature of the
hot wire to a certain amount. The heat generated by the hot wire is
reduced as ...
Cylinder head
Removal and Installation
1. Cylinder head
2. Cylinder head gasket
3. Cylinder head bolt
A. Follow installation procedure
REMOVAL
1. Remove the engine and transaxle assembly. Refer to EM-72, "Removal and
Installation".
2. Remove the timing chain. Refer to EM-52, "Removal ...