Nissan Altima 2007-2012 Service Manual: Park/neutral position switch

Removal and Installation

For removal and installation of park/neutral position switch, refer to TM-28, "Exploded View".

Inspection

• Check continuity.

    Back-up lamp switch
    Removal and Installation For removal and installation of back-up lamp switch, refer to TM-28, "Exploded View". Inspection • Check continuity. ...

    Control linkage
    Exploded View 1. Control lever knob 2. Control lever 3. Control device assembly 4. Retainer grommet 5. Select cable 6. Shift cable 7. Lock plate 8. Cable bracket Removal and Installation ...

    Other materials:

    Heater operation
    Heating This mode is used to direct heated air to the foot outlets. Some air also flows from the defrost outlets and the side vent outlets. 1. Press the button to the OFF position for normal heating. 2. Press  the air flow control button. 3. Turn the fan control dial to the desired ...

    P0850 PNP Switch
    Description When the shift lever position is P or N (CVT), Neutral position (M/T), park/neutral position (PNP) switch is ON. ECM detects the position because the continuity of the line (the ON signal) exists. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.INSPECTION START ...

    Ignition signal
    Description The ignition signal from the ECM is sent to and amplified by the power transistor. The power transistor turns ON and OFF the ignition coil primary circuit. This ON/OFF operation induces the proper high voltage in the coil secondary circuit. Component Function Check 1.INSPECTION ...