Nissan Altima 2007-2012 Service Manual: On-vehicle repair
On-vehicle maintenance
M/T OIL
Draining
1. Start engine and let it run to warm up transaxle oil.
2. Stop engine and remove the drain plug to drain the oil.
3. Install the drain plug with a new gasket to the transax ...
Side oil seal
Removal and Installation
REMOVAL
1. Remove the drive shaft. Refer to FAX-11, "Removal and Installation (Left
Side)", FAX-12, "Removal and
Installation (Right Side)".
2. Rem ...
Other materials:
M&A branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the combination meter for damage, bend
and loose connection
(unit side and connector side).
...
Camera on signal circuit (coupe)
Description
When the selector lever is placed in the R position, the rear view camera
control unit sends a camera ON signal
to the rear view camera.
Diagnosis Procedure
1.CHECK CAMERA ON SIGNAL CIRCUIT CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect rear view camera control unit con ...
Programming HomeLink®
If you have any questions or are having difficulty
programming your HomeLink® buttons, refer to
the HomeLink® web site at: www.homelink.com
or call 1-800-355-3515.
NOTE:
Place the ignition switch in the ACC position
when programming HomeLink®. It is
also recommended that a new battery be
...