Nissan Altima 2007-2012 Service Manual: Common item
Diagnosis Description
BCM CONSULT-III FUNCTION
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE: It can perform the diagnosis modes except the following for all sub system selection items.
CONSULT-III Function
ECU IDENTIFICATION
Displays the BCM part No.
SELF-DIAG RESULT
Refer to BCS-91, "DTC Index".
Wiper
CONSULT - III Function
WORK SUPPORT
* : Factory setting
DATA MONITOR
ACTIVE TEST
...
Other materials:
P1574 ASCD Vehicle speed sensor
Description
The ECM receives two vehicle speed signals via CAN communication line. One is
sent from combination
meter, and the other is from TCM (Transmission control module). The ECM uses
these signals for ASCD control.
Refer to EC-603, "System Description" for ASCD functions.
D ...
Oil cooler
Removal and Installation
1. Oil filter
2. Oil cooler bolt
3. Water pipe
4. Water hose
5. Oil cooler
6. O-ring
7. Oil pan
8. Water pipe
9. Relief valve
10. Water drain plug
11. Copper gasket
12. Water connector
WARNING:
Be careful not to get burned, engine coolant and engine oil may ...
Oil pressure switch signal circuit
Description
Detects the engine oil pressure and transmits the oil pressure switch signal
to the IPDM E/R.
Component Function Check
1.COMBINATION METER INPUT SIGNAL
1. Select “METER/M&A” on CONSULT-III.
2. Monitor “OIL W/L” of “DATA MONITOR” while operating ignition switch. ...