Nissan Altima 2007-2012 Service Manual: Diagnosis system (BCM)
Front wiper and washer system
System Diagram
System Description
OUTLINE
The front wiper is controlled by each function of BCM and IPDM E/R.
Control by BCM
• Combination switch reading function
• Front wiper control fu ...
Common item
Diagnosis Description
BCM CONSULT-III FUNCTION
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for ...
Other materials:
Rear-facing child restraint installation using the seat belts
WARNING
The three-point seat belt with Automatic
Locking Retractor (ALR) must be used
when installing a child restraint. Failure to
use the ALR mode will result in the child
restraint not being properly secured. The
restraint could tip over or be loose and
cause injury to a child in a sudde ...
B210D starter relay
Description
Located in IPDM E/R, it runs the starter motor. The starter relay is turned
ON by the BCM when the ignition
switch is in START position. IPDM E/R transmits the starter relay ON signal to
BCM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B210D is display ...
U1000 can comm circuit
Description
Refer to LAN-7, "System Description".
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
Diagnosis Procedure
1. PERFORM SELF DIAGNOSTIC
1. Turn ignition switch ON and wait for 2 second or more.
2. Check “Self Diagnostic Result” of IPDM E/R.
Is “CAN C ...