Nissan Altima 2007-2012 Service Manual: Wiper

 CONSULT - III Function

WORK SUPPORT

* : Factory setting

DATA MONITOR

ACTIVE TEST

    Common item
     Diagnosis Description BCM CONSULT-III FUNCTION CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for ...

    Diagnosis system (IPDM E/R)
    Diagnosis Description AUTO ACTIVE TEST Description In auto active test mode, the IPDM E/R sends a drive signal to the following systems to check their operation. • Oil pressure warning lamp ...

    Other materials:

    Diagnosis system (BCM)
    CONSULT-III Function (BCM) CONSULT-III DIAGNOSTIC MODES CONSULT-III can display each diagnostic item using the diagnostic test modes shown following. DESCRIPTION During driving, the tire pressure monitoring system receives the signal transmitted from the transmitter installed in each whe ...

    P0456 evap control system
    DTC Logic DTC DETECTION LOGIC This diagnosis detects very small leaks in the EVAP line between fuel tank and EVAP canister purge volume control solenoid valve, using the intake manifold vacuum in the same way as conventional EVAP small leak diagnosis. If ECM judges a leak which correspond ...

    P1701 transmission control module (power supply)
    Description When the power supply to the TCM is cut OFF, for example because the battery is removed, and the self-diagnosis memory function stops, malfunction is detected. NOTE: Since “P1701 TCM-POWER SUPPLY” will be indicated when replacing TCM, perform diagnosis after erasing “SE ...