Nissan Altima Owners Manual: Controls
Fan control dial
The fan control dial turns the fan on and off, and controls fan speed.
Air flow control buttons
The air flow control buttons allow you to select the air flow outlets.
MAX A/C - Air flows from center and side vents with maximum cooling.
- Air flows from center and side
vents.
- Air flows from center
and side
vents and foot outlets.
- Air flows mainly from foot
outlets.
- Air flows from defroster
outlets and
foot outlets.
- Air flows mainly from
defroster
outlets.
Temperature control dial
The temperature control dial allows you to adjust the temperature of the outlet air. To lower the temperature, turn the dial to the left. To increase the temperature, turn the dial to the right.
Air recirculation b
On position (Indicator light on):
Interior air is recirculated inside the vehicle.
Press the button to the ON position
when:
● driving on a dusty road.
● to prevent traffic fumes from entering passenger compartment.
● for maximum cooling when using the air conditioner.
Off position (Indicator light off):
Outside air is drawn into the passenger compartment and distributed through the selected outlet.
Use the off position or normal heater or air conditioner operation.
Air conditioner button
Start the engine, turn the fan control dial to the desired position and press the button to turn on the air conditioner. The indicator light comes on when the air conditioner is operating.
To turn off the air conditioner, press the button again.
The air conditioner cooling function operates only when the engine is running.
Rear window and outside mirror (if so equipped) defroster switch
For more information about the rear window and outside mirror (if so equipped) defroster switch, see “Rear window and outside mirror defroster switch” in the “Instruments and controls” section of this manual.
Heater and Air Conditioner (manual) (if so equipped)
1. Fan speed control / system OFF dial /
air conditioning (A/C) button
2. Air flow control buttons
3. Temperature control dial / MAX A/C
button
4. Air recirculation button
5. Rear window defro ...
Heater operation
Heating
This mode is used to direct heated air to the foot
outlets. Some air also flows from the defrost
outlets and the side vent outlets.
1. Press the button to the OFF
position
for normal h ...
Other materials:
Center speaker
Description
The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker
amp. amplifies the audio
signals before sending them to the center speaker using the audio signal
circuits.
Diagnosis Procedure
1.HARNESS CHECK
1. Disconnect BOSE speaker amp. connector B121 and cente ...
BCM (Body control module)
Reference Value
VALUES ON THE DIAGNOSIS TOOL
Terminal Layout
Physical Values
1: Sedan only
2: With LH front window anti-pinch
3: With LH and RH front window anti-pinch
4: With Intelligent Key
5: Without Intelligent Key
Wiring Diagram-Coupe
...
The ambient temperature display is
incorrect
Description
• The displayed ambient air temperature is higher than the actual
temperature.
• The displayed ambient air temperature is lower than the actual temperature.
Diagnosis Procedure
NOTE:
Check that the symptom is not applicable to the normal operating condition
before starting ...