Nissan Altima 2007-2012 Service Manual: CVT system

System Diagram

Component Parts Location - Coupe

1. Control device assembly

2. Accelerator pedal position sensor

3. CVT unit harness connector

4. Primary speed sensor

5. Secondary speed sensor

6. PNP switch

7. TCM

8. Battery

9. Shift position indicator Manual mode indicator

Component Parts Location - Sedan

1. Control device assembly

2. Accelerator pedal position sensor

3. CVT unit harness connector

4. Primary speed sensor

5. Secondary speed sensor

6. PNP switch

7. TCM

8. Battery

9. Shift position indicator Manual mode indicator

    Mechanical system
    Cross-Sectional View 1. Converter housing 2. Driven sprocket 3. Chain 4. Reverse brake 5. Oil pump 6. Forward clutch 7. Planetary carrier 8. Primary pulley 9. Sun gear 10. Steel belt 11. ...

    Other materials:

    P1800 Vias control solenoid valve 1
    Description The VIAS control solenoid valve 1 cuts the intake manifold vacuum signal for power valve 1 control. It responds to ON/OFF signals from the ECM. When the solenoid is OFF, the vacuum signal from the intake manifold is cut. When the ECM sends an ON signal the coil pulls the plunger ...

    Vehicle Dynamic Control (VDC) off switch
    The vehicle should be driven with the Vehicle Dynamic Control (VDC) system on for most driving conditions. If the vehicle is stuck in mud or snow, the VDC system reduces the engine output to reduce wheel spin. The engine speed will be reduced even if the accelerator is depressed to the flo ...

    B2556 push-button ignition switch
    Description The switch that changes the power supply position. BCM maintains the power supply position status. BCM changes the power supply position with the operation of the push-button ignition switch. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATIO ...