Nissan Altima 2007-2012 Service Manual: Function diagnosis
- CVT system
- Mechanical system
- Hydraulic control system
- Control system
- Lock-up and select control system
- Shift mechanism
- Shift lock system
- On board diagnostic (OBD) System
- Diagnosis system (TCM)
Inspection and adjustment
ADDITIONAL SERVICE WHEN REPLACING
CONTROL UNIT
Service After Replacing TCM
and Transaxle Assembly
Perform the applicable service in the following sheet when replacing TCM
or transaxle asse ...
CVT system
System Diagram
Component Parts Location - Coupe
1. Control device assembly
2. Accelerator pedal position sensor
3. CVT unit harness connector
4. Primary speed sensor
5. Secondary speed senso ...
Other materials:
Antenna AMP
Removal and Installation - Coupe
REMOVAL
1. Remove the rear pillar finisher RH. Refer to INT-20, "Exploded View".
2. Detach the antenna amp harness clip (B), disconnect the
antenna amp connectors (A), remove the antenna amp screw
(C) and remove the antenna amp (1).
INSTALLATION
...
Cooling fan control
System Diagram
System Description
INPUT/OUTPUT SIGNAL CHART
*1: The ECM determines the start signal status by the signals of engine speed
and battery voltage.
*2: This signal is sent to ECM through CAN communication line.
SYSTEM DESCRIPTION
ECM controls cooling fan speed correspondin ...
Camera image signal circuit (rear view camera to
camera control
unit)(coupe)
Description
Rear view camera images are transmitted to the rear view camera control unit
using the camera image signal
circuits.
Diagnosis Procedure
1.CHECK CAMERA IMAGE SIGNAL CIRCUIT CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect rear view camera control unit connector and rear v ...