Nissan Altima Owners Manual: Door locks/unlocks precaution

● Do not push the door handle request switch


● Do not push the door handle request switch with the Intelligent Key held in your hand as illustrated. The close distance to the door handle will cause the Intelligent Key system to have difficulty recognizing that the Intelligent Key is outside the vehicle.

● After locking with the door handle request switch, verify the doors are securely locked by testing them.

● To prevent the Intelligent Key from being left inside the vehicle, make sure you carry the Intelligent Key with you and then lock the doors.

● Do not pull the door handle before pushing the door handle request switch. The door will be unlocked but will not open. Release the door handle once and pull it again to open the door.

    Operating range
    The Intelligent Key functions can only be used when the Intelligent Key is within the specified operating range from the request switch 1 . When the Intelligent Key battery is discharged or st ...

    NISSAN Intelligent Key® operation
    You can lock or unlock the doors without taking the key out of your pocket or bag. When you carry the Intelligent Key with you, you can lock or unlock all doors by pushing the door handle requ ...

    Other materials:

    Diagnosis and repair workflow
    Work Flow OVERALL SEQUENCE DETAILED FLOW 1. GET INFORMATION FOR SYMPTOM Get the detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred). >> GO TO 2 2. CHECK DTC 1. Check DTC. 2. Perform the following ...

    Air cleaner and air duct
    Removal and Installation 1. Air duct hose 2. Front air duct 3. Air cleaner mounting bracket 4. Air cleaner assembly 5. Mass air flow sen A. To electric throttle control actuator REMOVAL 1. Remove front air duct. 2. Disconnect the air duct hose clamps at the electric throttle control act ...

    Main line between dlc and abs circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side). - Harness c ...