Nissan Altima Owners Manual: Emission control information label

The emission control information label is attached


The emission control information label is attached to the underside of the hood as shown.

    F.M.V.S.S./C.M.V.S.S. certification label
    The Federal/Canadian Motor Vehicle Safety Standard (F.M.V.S.S./C.M.V.S.S.) certification label is affixed as shown. This label contains valuable vehicle information, such as: Gross Vehicle Weight ...

    Tire and loading information label
    The cold tire pressure is shown on the Tire and Loading Information label. The label is located as shown. ...

    Other materials:

    Bose speaker AMP
    Diagnosis Procedure 1.CHECK FUSE Check for blown fuses. Are the fuses OK? YES >> GO TO 2 NO >> Be sure to eliminate cause of malfunction before installing new fuse. 2.CHECK POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect BOSE speaker amp connector. 3. Chec ...

    Transmission control module
    Exploded View 1. TCM 2. Bracket 3. Battery Removal and Installation REMOVAL 1. Disconnect the battery negative terminal. 2. Remove the fresh air intake tube (upper). 3. Disconnect the TCM harness connector. 4. Remove the TCM (1) from the bracket (2). • Battery (3) INSTALL ...

    P0840 transmission fluid pressure sensor A (sec pressure sensor)
    Description The transmission fluid pressure sensor A (secondary pressure sensor) detects secondary pressure of CVT and sends TCM the signal. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn igni ...