Nissan Altima 2007-2012 Service Manual: Function diagnosis
- Intelligent key system/engine start function
- NVIS (Nissan vehicle immobilizer system-nats)
- Vehicle security system
- Diagnosis system (BCM)
Inspection and adjustment
ECM RE-COMMUNICATING FUNCTION
Description
Performing following procedure can automatically perform re-communication of
ECM and BCM, but only when
the ECM has been replaced with a new one (*1).
...
Intelligent key system/engine start function
System Diagram
System Description
INPUT/OUTPUT SIGNAL CHART
SYSTEM DESCRIPTION
• The engine start function of Intelligent Key system is a system that makes
it possible to start and stop ...
Other materials:
P0507 ISC System
Description
The ECM controls the engine idle speed to a specified level through the fine
adjustment of the air, which is let
into the intake manifold, by operating the electric throttle control actuator.
The operating of the throttle valve is
varied to allow for optimum control of the engine ...
P2138 APP sensor
Description
The accelerator pedal position sensor is installed on the upper end
of the accelerator pedal assembly. The sensor detects the accelerator
position and sends a signal to the ECM.
Accelerator pedal position sensor has two sensors. These sensors
are a kind of potentiometer which tran ...
P0101 Maf sensor
Description
The mass air flow sensor (1) is placed in the stream of intake air. It
measures the intake flow rate by measuring a part of the entire
intake flow. The mass air flow sensor controls the temperature of the
hot wire to a certain amount. The heat generated by the hot wire is
reduced as ...