Nissan Altima (L32) 2007-2012 Service Manual: Function diagnosis
- Relay control system
- Power control system
- Signal buffer system
- Power consumption control system
- Diagnosis system (IPDM E/R)
Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW Work Flow OVERALL SEQUENCE DETAILED FLOW 1. GET INFORMATION FOR SYMPTOM Get the detailed information from the customer about the symptom (the condition and the ...Relay control system
System Diagram System Description IPDM E/R activates the internal control circuit to perform the relay ON-OFF control according to the input signals from various sensors and the request signal ...Other materials:
P0643 sensor power supply
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn
ignition switch OFF and wait at
least 10 seconds before conducting the next test.
TESTING CONDITION:
Before performing the following proced ...
B2617 Starter relay circuit
Description
Located in IPDM E/R, it runs the starter motor. The starter relay is turned
ON by the BCM when the ignition
switch is in START position. IPDM E/R transmits the starter relay ON signal to
BCM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2617 is display ...
BCM (Body control module)
Diagnosis Procedure
1. CHECK FUSE AND FUSIBLE LINK
Check if the following BCM fuse or fusible link are blown.
Is the fuse or fusible link blown?
YES >> Replace the blown fuse or fusible link after repairing the affected
circuit.
NO >> GO TO 2
2. CHECK POWER SUPPLY CIRCUIT
1. ...