Nissan Altima Owners Manual: How to switch the display

A : Original screen before the RearView Monitor


A : Original screen before the RearView Monitor is operated
B : Rear-wide view screen C : Rear view screen
1 : Shift lever is moved into the R (Reverse) position
2 : Shift lever is moved out of the R (Reverse) position
3 : Select the “View” key on the screen

● When the shift lever is moved into the R (Reverse position 1 while another screen A is displayed, RearView Monitor operates and the rear-wide view B is displayed.

● When selecting the “View” key on the screen using the multi-function controller and pressing the ENTER button 3 , the view on the screen will change to the rearview screen C . When the “View” key is pressed again 3 , the rear-wide view B is displayed.

● The rear-wide view screen and/or rear view screen switches to another screen A when the shift lever is moved out of the R (Reverse) position

Rear view


Rear view

Guiding lines which indicate the vehicle width and distances to objects with reference to the bumper line A are displayed on the monitor.

Distance guide lines:

Indicate distances from the bumper.

● Red line 1 : approx. 1.5 ft (0.5 m) ● Yellow line 2 : approx. 3 ft (1 m) ● Green line 3 : approx. 7 ft (2 m) ● Green line 4 :approx.10 ft (3 m)

Vehicle wideth guide lines 5 :

Indicates the vehicle width when backing up.

    Rear and rear-wide view monitor with moving object detection (MOD) (if so equipped)
    When the shift lever is shifted into the R (Reverse) position, the monitor display shows view to the rear of the vehicle. The system is designed as an aid to the driver in detecting large statio ...

    How to park with predicted course lines
    WARNING ● Always turn and check that it is safe to do so before backing up. Always back up slowly. ● Use the displayed lines as a reference. The lines are highly affected by the num ...

    Other materials:

    P0500 VSS
    Description The vehicle speed signal is sent to the combination meter from the “ABS actuator and electric unit (control unit)” by CAN communication line. The combination meter then sends a signal to the ECM by CAN communication line. DTC Logic DTC DETECTION LOGIC NOTE: • If ...

    Pre-inspection for diagnostic
    Basic Inspection The engine start function, door lock function, power distribution system and NATS-IVIS/NMS in the Intelligent Key system are closely related to each other regarding control. Narrow down the functional area in question by performing basic inspection to identify which function ...

    Measurement of weights
    Secure loose items to prevent weight shifts that could affect the balance of your vehicle. When the vehicle is loaded, drive to a scale and weigh the front and the rear wheels separately to determine axle loads. Individual axle loads should not exceed either of the gross axle weight ratings ( ...