Nissan Altima 2007-2012 Service Manual: Lighting and turn signal switch

Removal and Installation

Removal

1. Remove the spiral cable. Refer to SR-8, "Removal and Installation" 2. Disconnect the lighting and turn signal switch connector and remove the lighting and turn signal switch.

Installation

Installation is in the reverse order of removal.

    Rear combination lamp
    Bulb Replacement Removal 1. Remove the rear combination lamp. Refer to EXL-260, "Removal and Installation". 2. Turn the rear turn signal lamp bulb socket counterclockwise and remove ...

    Hazard switch
    Removal and Installation Removal 1. Remove the cluster lid C. Refer to IP-12, "Removal and Installation". 2. Remove CVT finisher or M/T finisher. Refer to TM-255, "Removal and In ...

    Other materials:

    B1081 – B1084 seat belt pre-tensioner RH
    Description DTC B1081 – B1084 SEAT BELT PRE-TENSIONER RH The seat belt pre-tensioner RH is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor unit will monitor for opens and shorts in detected lines to the seat belt pre-tensioner RH. PART LOCATION Refer to SRC-7, &qu ...

    Anti-pinch system does not operate normally (driver side)
    Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement". Is the inspection result normal? YES >> GO TO 2 NO >> Repair or replace the mal ...

    ECM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). - ECM - Harnes ...