Nissan Altima 2007-2012 Service Manual: Locks, hinges and hood latch

Lubricating- Coupe

 Lubricating - Sedan

    Drive shaft
    Inspection Check boot and drive shaft for cracks, wear, damage and grease leakage. ...

    Seat belt, buckles, retractors, anchors and adjusters
    Inspection CAUTION: • After any collision, inspect all seat belt assemblies, including retractors and other attached hardwares (I.e. anchor bolt, guide rail set). Nissan recommends to replace a ...

    Other materials:

    How to read wiring diagrams
    Connector symbols Most of connector symbols in wiring diagrams are shown from the terminal side. • Connector symbols shown from the terminal side are enclosed by a single line and followed by the direction mark. • Connector symbols shown from the harness side are enclosed by a doubl ...

    Can communication circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the IPDM E/R for damage, bend and loose connection (unit side and connector side). Is the in ...

    P0112, P0113 IAT sensor
    Description The intake air temperature sensor is built-into the mass air flow sensor (1). The sensor detects intake air temperature and transmits a signal to the ECM. The temperature sensing unit uses a thermistor which is sensitive to the change in temperature. Electrical resistance of the ...