Nissan Altima Owners Manual: Manual control

While using the Voice Recognition system, it is possible to select menu options by using the steering wheel controls instead of speaking voice commands. To activate manual control mode, press the PHONE/SEND ( the) button on
the steering wheel to access the phone menu and then press either up or down on the tuning switch ( ).


The manual control mode does not allow dialing a phone number by digits. The user may select an entry from the Phonebook or Recent Calls lists.

To reactivate Voice Recognition, exit the manual control mode by pressing and holding the PHONE/END (pressing ) button. At that time,
pressing the PHONE/SEND ( start) button will
start the Hands Free Phone System.

    Bluetooth® settings
    To access and adjust the settings for the Bluetooth® Hands-Free Phone System: 1. Press the SETTING button. 2. Use the TUNE/SCROLL knob to select “Bluetooth” and then press the ENTER button: ...

    Bluetooth® Hands-Free Phone System with Navigation System (if so equipped)
    WARNING ● Use a phone after stopping your vehicle in a safe location. If you have to use a phone while driving, exercise extreme caution at all times so full attention may be given to vehic ...

    Other materials:

    CSC (Concentric slave cylinder)
    Exploded View 1. Transaxle assembly 2. CSC (Concentric Slave Cylinder) Removal and Installation CAUTION: • If transaxle assembly is removed from the vehicle, always replace CSC. Return CSC insert to original position to remove transaxle assembly. Dust on clutch disc sliding parts may ...

    Power supply and ground circuit for front air control
    Description FRONT AIR CONTROL The front air control has a built-in microcomputer which processes information sent from temperature control dial and various switches needed for air conditioner operation. The air mix door motor, mode door motor, intake door motor, blower motor and compressor are ...

    Main line between dlc and abs circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side). - Harness co ...