Nissan Altima 2007-2012 Service Manual: Rear parcel shelf finisher
Exploded View
1. Seatback release escutcheon
2. Seatback release cover
3. Child anchor cover
4. Seatback latch cover
5. Rear parcel shelf finisher
6. High mounted stop lamp (if equipped)
A. Clip C205
Removal and Installation
REMOVAL
1. Release seatback latch RH/LH, then fold both rear seatbacks to forward most position.
2. Remove the clips, then remove rear seatback latch cover.
3. Lift seatback release cover, release the tabs and remove seatback release escutcheon from rear parcel shelf finisher.
4. Remove high mounted stop lamp (if equipped). Refer to INT-36, "Removal and Installation".
5. Remove rear pillar finisher RH/LH. Refer to INT-36, "Removal and Installation".
6. Thread the rear seat belt RH/LH/Center through vertical opening and release from rear parcel shelf finisher.
7. Remove the clips, then remove rear parcel shelf finisher.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION: Make sure that clips are fully aligned with panel holes on body when installing, then press them in completely.
Body side trim
Exploded View
1. Front pillar finisher
2. Dash side lower finisher
3. Front kicking plate
4. Front sill cover
5. Center pillar lower finisher
6. Rear sill cover
7. Rear kicking plate
8. Rear ...
Floor trim
Exploded View
1. Spacer (RH)
2. Spacer (LH)
3. Floor mat hook
4. Floor carpet
5. Harness clamp
Removal and Installation
REMOVAL
1. Remove front seat (RH/LH) and rear seat cushion. Refer ...
Other materials:
B260F engine status
Description
BCM receives the engine status signal from ECM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B260F is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to
SEC-235, "DTC Logic".
• If DTC B260F is displayed w ...
Door outside molding
Removal and Installation
1. Front door outside molding
2. Front door
Door Outside Molding
Removal
1. Open the front door window fully.
2. Remove the side view mirror. Refer to MIR-19, "Removal and Installation".
3. Lift and twist front door molding from rear end, disconnect ...
Low tire pressure warning lamp
stays on
Low Tire Pressure Warning Lamp Stays On When
Ignition Switch Is Turned On
DIAGNOSTIC PROCEDURE
1.CHECK BCM CONNECTORS
1. Turn ignition switch OFF.
2. Disconnect BCM harness connectors.
3. Check terminals for damage or loose connections.
Is the inspection result normal?
YES >> GO ...