Nissan Altima 2007-2012 Service Manual: Stop lamp

Bulb Replacement

Removal

1. Remove rear combination lamp. Refer to EXL-257, "Removal and Installation".

2. Turn bulb socket counterclockwise to unlock and remove from combination lamp assembly.

3. Turn bulb counterclockwise to remove from bulb socket.

Installation

Installation is in the reverse order of removal.

Removal and Installation

HIGH MOUNTED STOP LAMP (with rear spoiler)

The high-mounted stop lamp uses an LED circuit board instead of a bulb. The LED circuit board is not serviceable and the high-mounted stop lamp must be replaced as an assembly. Refer to EXT-47, "Removal and Installation".

HIGH-MOUNTED STOP LAMP (with parcel shelf)

Removal

1. Slide the high-mounted stop lamp assembly rearward on the parcel shelf to give clearance to the front tabs.

2. Lift the front of the lamp assembly up and slide it forward to give clearance to the rear tabs.

3. Disconnect the high-mounted stop lamp connector and remove.

Installation


Installation

Installation is in the reverse order of removal.

REAR COMBINATION LAMP

Removal

1. Remove the trunk side finisher. Refer to INT-46, "Removal and Installation".

2. From inside the trunk, remove the rear combination lamp assembly nuts.

3. Disconnect the connectors and remove the rear combination lamp assembly.

Installation

Installation is in the reverse order of removal.

    Front fog lamp
    Bulb Replacement REMOVAL The fog lamp is a semi-sealed beam type which uses a replaceable halogen bulb. CAUTION: • Do not touch the glass of bulb directly by hand. Keep grease and other o ...

    Back-up lamp
    Bulb Replacement Removal 1. Remove the rear combination lamp. Refer to EXL-260, "Removal and Installation". 2. Turn back-up lamp bulb socket counterclockwise to unlock and remove. ...

    Other materials:

    P0340, P0345 CMP sensor (phase)
    Description The camshaft position sensor (PHASE) senses the protrusion of camshaft (INT) to identify a particular cylinder. The camshaft position sensor (PHASE) senses the piston position. When the crankshaft position sensor (POS) system becomes inoperative, the camshaft position sensor (PHAS ...

    Tire Pressure Monitoring System (TPMS)
    Each tire, including the spare (if provided), should be checked monthly when cold and inflated to the inflation pressure recommended by the vehicle manufacturer on the vehicle placard or tire inflation pressure label. (If your vehicle has tires of a different size than the size indicated on th ...

    On board diagnostic (OBD) system
    Diagnosis Description DESCRIPTION The CVT system has two self-diagnostic systems. The first is the emission-related on board diagnostic system (OBD-II) performed by the TCM in combination with the ECM. The malfunction is indicated by the MIL (malfunction indicator lamp) and is stored as a ...