Nissan Altima Owners Manual: Telescopic operation

Pull the lock lever down 1 and adjust the steering wheel forward or backward 3 to the desired position.

Push the lock lever up 1 firmly to lock the steering wheel in place.

WARNING

Do not adjust the steering wheel any closer to you than is necessary for proper steering operation and comfort. The drivers air bag inflates with great force. If you are unrestrained, leaning forward, sitting sideways or out of position in any way, you are at greater risk of injury or death in a crash. You may also receive serious or fatal injuries from the air bag if you are up against it when it inflates. Always sit back against the seatback and as far away as practical from the steering wheel. Always use the seat belts.

    Tilt operation
    Pull the lock lever down 1 and adjust the steering wheel up or down 2 to the desired position. Push the lock lever up 1 firmly to lock the steering wheel in place. WARNING Do not adjust the s ...

    Sun visors
    1 To block glare from the front, swing down the main sun visor. 2 To block glare from the side, remove the main sun visor from the center mount and swing the visor to the side. 3 To extend (if ...

    Other materials:

    B2108 steering lock relay
    Description The steering lock relay ON signal is transmitted to IPDM E/R by BCM via CAN communication. IPDM E/R turns the steering lock relay ON and transmits the release of the steering to BCM. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2108 is displayed with DTC U1000, first perf ...

    M&A branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the combination meter for damage, bend and loose connection (unit side and connector side). ...

    BCM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the BCM for damage, bend and loose connection (unit side and connector side). Is the inspec ...